- The ‘pre-wash’ compartment. So, the pre-wash compartment is where you pop in some detergent when you’re going to do a ‘pre-wash’ cycle.
- The ‘main wash’ compartment.
- The ‘fabric softener’ compartment.
Where do you put liquid detergent in a Whirlpool washer?
How do you remove the whirlpool detergent drawer?
How does Whirlpool detergent dispenser work?
What are the 3 compartments in a washing machine drawer whirlpool? – Related Questions
Why is my Whirlpool washer not dispensing soap?
The dispenser may be clogged if your additives do not release into the wash. A clogged dispenser can block the flow of water through the dispenser. Remove the dispenser, by pressing the release lever and rinse leftover detergent or additives that could clog the flow of water through the dispenser.
Why does water stay in detergent drawer?
Detergent can gradually build up in the detergent tray and its attachments over time. If these are not cleaned regularly, the water and additives will not dispense fully and water will remain in the compartments.
How does a washing machine detergent dispenser work?
How does detergent dispenser work?
The detergent dispenser will automatically open and release the soap at the correct time in the washing cycle. Water is shot through jets on the bottoms and sides of the dishwasher to get all the dishes. Dirty water is drained and jets turn back on to rinse the dishes.
How do you use the soap dispenser on a Whirlpool dishwasher?
To Use the Detergent Dispenser:
- Place detergent in the dispenser.
- Place finger on the lid as shown and slide the lid closed.
- Press firmly until it clicks.
What triggers a soap dispenser?
Infrared sensors detect infrared energy that is emitted by one’s body heat. When hands are placed in the proximity of the sensor, the infrared energy quickly fluctuates. This fluctuation triggers the pump to activate and dispense the designated amount of soap.
How do I fix my soap dispenser not pumping?
First, unscrew the dispenser and remove the trigger and pump section of the soap dispenser. Take this section and put it in hot water to soak for approximately 10-15 minutes. Then after soaking to dislodge the solidified soap, pump water through the pump until it runs clear.
What do you do when your soap dispenser won’t pop up?
Why wont my soap dispenser work?
If you are experiencing this issue, the first thing to check is the sensor area. The sensor area might be obstructed by soap or sanitizer residue. Clean the area, removing any visible residue, and test the unit. Pro Tip: Do not use abrasive cleaners on the dispenser or cartridge.
How do you reset a soap dispenser?
Try a soft reset, by pressing power button for 12 seconds and then power on the device. If your soap dispenser isn’t used for a prolonged time, soap can accumulate and clog the nozzle. To troubleshoot, clean the nozzle area with water and remove any stuck soap.
How do you trigger a dispenser?
How do I get my automatic soap dispenser to work?
How do you activate a soap pump?
How do you get the pump up on a soap dispenser?
How do you prime a soap dispenser pump?
To prime the pump
Use your thumb or finger to cover the hole at the bottom of the dispenser where the soap gets dispensed out of. While still covering the hole, push the button all the way in. While still covering the hole, let the button depress naturally. All done!