Open the dispenser drawer by pulling on the handle at the base of the washer. This will reveal the drain pump filter.
Do Whirlpool Cabrio washers have a filter?
All whirlpool washers have a filter, and the location of the filter will vary depending on the model of the washer. In most cases, the filter can be found behind the agitator or near the bottom of the washer tub. But you always need to check your manufacturer’s manual for the exact location of your model.
Does a Whirlpool top load washer have a filter to clean?
Step 1: Locate the filter
Usually, it will be on the bottom right of the washing machine, making access rather easy. Of course, your model may be different so you may need to consult the user’s manual or give your washer a quick look over to find it.
How do I clean my Whirlpool Cabrio top load washer?
Where is the filter on a Whirlpool Cabrio washer? – Related Questions
How do you clean the lint trap on a Whirlpool Cabrio?
If your lint screen has residue on it, clean it by wetting a nylon brush with hot water and liquid detergent.Scrub both sides of the lint screen, and then rinse each side thoroughly with hot water. Inspect the lint screen to be sure you have removed all residue.
Why does my Whirlpool Cabrio washer stink?
To Clean a Front-Load Washer Door Seal and Gasket:
Make sure to clean the inside of the rubber gasket or door seal. Mold, mildew, and debris tend to accumulate in the door seal, contributing to the Whirlpool washer smells. Rinse the area with clean water and dry it with a soft cloth.
How do I clean my Whirlpool top loader washing machine?
Run the Clean Washer cycle every 30 cycles to maintain washer freshness. This procedure helps keep odors from developing in your washer. The Clean Washer cycle uses higher water volumes in combination with affresh® washer cleaner or liquid chlorine bleach to clean the inside of the washer.
How do I clean sludge out of my top loader washing machine?
Clean the Washing Machine with Vinegar Again fill the washer with HOT water but this time add one quart of white vinegar. Same routine-set on the longest cycle and let it agitate a few minutes then sit for one hour. After the hour complete the wash and rinse cycle.
How do I clean my Whirlpool top load washer without affresh?
If you don’t have affresh® tablets you may be able to use liquid chlorine bleach, but check your use and care guide first. Close the door and select your washer’s cleaning cycle or a normal cycle with hot water setting.
How do you run a clean cycle on a top load washer?
For a front-load washer, put 2 tablespoons of oxygen bleach or borax and 2 tablespoons of washing soda in the tub of the washing machine. For a top-loading machine, put 1/2 cup of each of the powders into the wash tub. Run the biggest cycle at the hottest temperature or use the “clean tub” setting on the washer.
How do you run a clean cycle on a Whirlpool Cabrio?
Is there a filter to clean in a top load washing machine?
“Top loaders tend to have filters on the valves,” said Amber Peabody, Service Manager at Dunnett Inc. The valve filters sift the water going in and out of the pump and hoses. If you do happen to have a removable filter, consult your owner’s manual on how to properly remove it.
How do I run the clean cycle on my Whirlpool washer?
Close the washer lid or door. Select the CLEAN WASHER cycle. Touch and hold the START/PAUSE button for 3 seconds to begin the cycle. After this cycle is complete, leave the lid or door open to allow for better ventilation and drying of the washer interior.
Is Whirlpool Cabrio discontinued?
Whirlpool Cabrio WTW5700XW has been discontinued.
How do you run a self cleaning cycle?
To run a Self Clean cycle, make sure the washer is empty, press Self Clean, and then press Start. You don’t need to add any cleaner when running self clean. However, we do recommend using bleach if you already have an existing mold smell (see our guide for details).
What do I put in my washing machine for self cleaning mode?
First, Run the Washing Machine’s Self-Clean Cycle
Baking soda will help neutralize any “off” smells and give your washing machine a little extra cleaning power. If you’ve noticed mildew or a moldy smell, add bleach during the self-cleaning cycle to get rid of it.
Is bleach or vinegar better to clean washing machine?
If you’re a fan of bleach in the laundry sphere, you’re in luck because it might just be the hardest-working product for sanitizing. If you want to avoid bleach and its harsh chemicals, though, white vinegar is a good alternative with powerful deodorizing and bacteria-killing properties.
Can vinegar damage your washing machine?
Vinegar is sometimes used as a fabric softener or for getting rid of stains and odors in laundry. But as with dishwashers, it can damage the rubber seals and hoses in some washing machines to the point of causing leaks.