Nationally, you can expect to pay about $450 on average for a blower motor replacement, including labor. However, if your unit is under warranty, you might get away with a labor-only charge of as little as $150. More complicated units, or units that are difficult to access, can cost as much as $2,000 to replace.
How much does it cost to replace an air conditioner motor?
When your air conditioner’s fan motor breaks, it will typically cost about $300 to $600 to replace. However, if your AC fan motor is under warranty, it could cost $100 to $300 – if your AC fan motor is not under warranty, it could cost between $200-$700.
How much does it cost to replace an ECM blower motor?
ECM blower motor replacement cost. Replacing a permanent split capacitor (PSC) blower motor costs $300 to $1,100 with installation. An electronically commutated (ECM) blower motor replacement costs $600 to $1,500.
How much does it cost to replace a fan motor?
What’s the Cost of Repairing or Replacing a Fan Motor? The average cost of a condenser fan motor is between $300 and $500 (not including installation). If the compressor breaks, you are looking at a much costlier problem which could cost up to $2000. In some cases, your fan motor may be under warranty.
How much should it cost to replace a furnace blower motor? – Related Questions
Is it worth it to replace a motor?
If the rest of the vehicle is in good condition mechanically and is a newer vehicle, an engine replacement could be the best option budget-wise. Engine replacement or rebuilding can be cost-effective when it comes to saving money rather than spending thousands on a new vehicle.
What causes fan motors to fail?
The main causes of failure are loss of lubricant, a failed run capacitor, a failed bearing in a belt drive, a little water dripping into the windings or a voltage problem. So technicians should carefully check to find the cause of a failure before changing the motor.
How do I know if my fan motor is blown?
The most telltale signs that there’s an issue with the fan motor are:
- The cooling fans won’t turn on.
- The fan turns on when the AC is running, but the blades rotate slowly.
- You can hear a rattling noise coming from the condenser unit.
- It smells like something’s burning.
- Blown fuse.
How do I know if my fan motor is broken?
Signs and Symptoms of a Bad AC Fan Motor
- The fan won’t start even though the AC is on.
- The fan won’t stop, even when you shut the AC off.
- The fan turns on, yet the blades are rotating very slowly.
- There’s a rattling noise coming from the condenser unit when the fan is turned on.
What is the labor cost to replace an AC fan motor?
An HVAC technician will charge anywhere between $75 and $250 per hour depending on where you live. It may take a technician between one and three hours to replace your condenser fan motor and many will also charge a minimum service fee. Expect a total condenser fan motor replacement to cost between $150 and $750.
Can you replace the motor in a fan?
Luckily, a broken 12-volt fan motor can be replaced at home. Here’s how to take out the old fan and put in a new one, complete with step-by-step photos. It’s hot. Really hot.
Is it worth repairing an electric motor?
If the extent of the damage to your motor is not too significant, then we would always advise going for electric motor repair. It is a much more cost-effective and environmentally friendly solution, especially if only certain parts of the motor need repairing.
What are the common defects of a fan motor?
A Common Problem
Signs of fan motor problems can include, but are not limited to the following: The exhaust fan blowing outside, but no air moving inside. Buzzing or grinding noises as the motor struggles to function. Electrical issues, such as the circuit breaker shutting off power to the unit.
Do fan motors burn out?
Like any motor, an air conditioner fan motor can become overheated if it works too hard and doesn’t receive proper maintenance. If your AC has worked for you most of the summer, the stress could cause the fan motors to burn out.
How do you tell if a motor is shorted out?
To test your motor for short to ground, you’ll need to set the multimeter to ohms and disconnect the motor from its power source. Then inspect each wire and look for infinite readings. Alternatively, if you get a reading of 0, you might have a cable issue.
Can you fix a burnt fan motor?
If an electric motor operates at too high a voltage, excess current flowing through the windings can cause them to become hot and burn out. While it is normally not practical to repair small, direct current (DC) motors that have burned out, other motors can be repaired by rewinding.
What causes a fan motor to overheat?
Lack of maintenance: This is probably the most common reason that causes condenser fan motors to overheat and shut off. Proper and regular lubrication of the fan motor is necessary for the motor to run smoothly. Periodically making sure that there’s no debris or dust in or around the fan motor is also a good idea.
What happens if a motor starts to overheat?
Increases in the temperature of an electric motor reduce its lifespan. The winding insulation deteriorates, and the bearings may also deteriorate.
What to do if motor is overheating?
5 steps to take when you have an engine overheating:
- Turn on the heater. It sounds counterintuitive, but Reina recommends turning on the heater.
- Sit tight. If you don’t have roadside assistance, be patient; it will take at least 15 minutes for the engine to cool.
- Add coolant.
- Drive to a service station.
What happens if fan motor fails?
The fan motor can cause significant damage to your system if it’s not working properly. If the fan motor is stuck, it could cause the compressor to overheat and fail, which can cause your entire system to break down.
How do you fix a fan motor that won’t spin?
Whether the blades aren’t spinning or the fan is making tons of noise, most issues with an electric fan are caused by poor lubrication or blockages in the vents. To solve most problems with an electric fan, disassemble the fan, lubricate the central pin and bearings, and clean out the vent and motor case.