Reconnect the power, then lift and close the lid six times in a 12-second interval.
Keep in mind that for the procedure to function, the lid must close properly six times in a row.
Run a test load afterward to confirm that the washer has reset.
How long does a washer stay on sensing?
These sensing spins may take 2 to 3 minutes before water is added to the load. The washer will then move the load briefly, pause to allow water to soak into the load, and resume adding water. This process may repeat until the correct amount of water has been added to the load.
How do I reset my Maytag error code?
Press the Pause or Cancel button twice and the Power button once to clear the code.
Why does my washer stop at sensing fill?
There are several possible reasons why your washing machine may be stuck on sensing fill. The most common reasons include overloading of the drum, a clogged inlet screen, a faulty inlet valve, or a failure of the main control board.
How do you reset the sensor on a Maytag washer? – Related Questions
How do you bypass a washing machine sensing?
Here is a simple way to do this:
Let us say you have 2 lbs of clothes.
Add the 2 lbs of clothes in the washtub.
Before commencing the wash cycle, pour 4 lbs of water over the clothes and let water to soak into the fabric.
Start the wash cycle.
You have successfully bypassed water level sensor.
How do you reset the washing machine sensor?
How do I reset my Whirlpool auto load sensing washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP.Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
Why is the sensing fill light flashing?
See the following troubleshooting link: http://products.geappliances.com/appliance/gea-support-search-content?contentId=16539 If the fill light flashes, check your house water supply. As soon as the light starts to flash, the washer will initiate a 4 minute lock-out period.
How do I reset the sensor on my LG washer?
Why is my Amana stuck on sensing fill?
SENSING/FILL Light is on
NOTE: If the fill light is on, and there is no or little water coming in, check your water supply lines. Both water lines should be completely open (turned on) for the washer to operate correctly.
What does sensing fill mean?
SENSING/FILL Light is on
When the Start/Stop button is pressed, and the Water Level knob is set to Auto Sensing, the washer will fill and begin sensing to determine load size and balance.
How do I reset the sensor on my Amana washing machine?
First, unplug the washing machine for a few minutes that will reset the machine and clear the flashing light.Press and hold the End of Cycle or Cycle Signal button for twenty seconds. This process also reset your Amana washer and clear the flashing light.
How do I reset the lid lock on my Amana washer?
Door Locked at the end of the Cycle
If the washer will not unlock at the end of a wash cycle, unplug the washer or disconnect power. Wait approximately 2 minutes for control to reset. Reconnect power to washer (plug in).
How do you bypass the lid lock switch on a washing machine?
Why is my washer stuck on lid lock?
– A piece of lint or washing machine detergent has built up over time and hinders the locking of the lid. – The control board sees an open lid switch when it attempts to lock. – The lid switch is not working either mechanically or electrically and needs to be adjusted or replaced.
Is there a way to bypass the lid switch on a washing machine?
How do I know if my washing machine lid switch is broken?
You will need to remove the two-wire harnesses off the lid switch, While you can unmount the lid switch, at this point you only need to test it with a multimeter. Set your multimeter to the lowest ohms of resistance and test your lid switch. If it does not read any continuity, then your lid switch is indeed faulty.