Set your washer to the hottest and largest setting and start the cycle.
Add 1 quart of bleach to the water and let the water agitate for a minute so that it mixes well.
Lift the machine’s lid and let it sit, full of bleach, for an hour.
After the hour, close the cover and let it run an entire cycle.
How do I clean my Maytag washer cycle?
STEP 1: CLEAN THE WASHER TUB
Remove any items left in the tub.
Add an affresh® washing machine cleaner tablet to the bottom of the tub.
Close the door and select your washer’s cleaning cycle.
For top load washers, when the cycle ends, run a rinse and spin cycle to clear away any excess cleansers.
How do I clean the filter on my Maytag washer?
The following steps detail how to clean Maytag washing machine filter in front-load models quickly and easily.
Step 1: Open Drain Dispenser Drawer.
Step 2: Drain the Pump Hose.
Step 3: Take Out the Drain Pump Filter.
Step 4: Remove Lint and Debris.
Step 5: Replace the Drain Pump Filter.
Step 6: Secure the Dispenser Drawer.
How do you clean a smelly Maytag washer?
Here’s how to clean the interior when your Maytag washer smells like mildew:
Sprinkle ⅓ cup of baking soda inside the empty washer tub and close the door.
Pour 2 cups of white vinegar in the detergent dispenser.
Start a regular wash cycle with hot water and run it to completion.
How do I deep clean my Maytag top load washer? – Related Questions
Why does my Maytag washer smell like sewer?
You use too much detergent
This is ironic, but using too much detergent can also cause your wash machine to smell like a sewer. If you do not use enough water to do your laundry, a lot of detergents would be left after washing.
Why does my Maytag washer smell so bad?
If your Maytag washer smells like rotten eggs, there’s likely a buildup of mildew in the washer tub. Cleaning the tub on a monthly basis, or every 30 wash cycles, can prevent buildup and curb odor. Some washers have a Clean Washer cycle that performs a tub cleaning.
How do I clean my deeply smelly washing machine?
Baking Soda & Vinegar Wash
Mix ¼ cup of baking soda with ¼ cup of water and add it to your machine’s detergent container.
Use four cups of plain white (not apple cider) vinegar to a top-load machine or two cups to a front-load model.
Pour the vinegar into the drum.
Run a high-temperature cycle.
How do I stop my washing machine from smelling like rotten eggs?
Solutions When a Washing Machine Smells Like Rotten Eggs
This is one of the most common causes of a front-load washer smell. You can clean the seal of your washer with a mixture of water and vinegar, which will remove debris without harming the rubber. The next issue could be related to your drain or pump.
Can I use vinegar to clean my Maytag washer?
Cleaning Tips
Mix 1/4 cup with the same amount of water and add it to the detergent slot of your washing machine. Then, in the drum of the machine, add two cups of white vinegar, suggests Reviewed.com Laundry. Run a normal load and allow the baking soda and vinegar to work their magic.
Where is the filter on my Maytag washing machine?
How do you clean a top load washer filter?
Step 1: Wipe the Filter and Housing. Open the filter housing and wipe away lint and debris using paper towels.
Step 2: Scrub the Filter. Using a soft-bristle brush, such as an old toothbrush or dish brush, scrub the filter to remove lint and debris that has built up on the filter.
Step 3: Run a Short Wash Cycle.
How do you open the filter on a Maytag washing machine?
How do I know if my washing machine has a filter?
The pump filter is responsible for protecting the pump from a build-up of lint and other obstructions. It should have a retractable pipe at the side so that you can drain the water. The filter is either obvious at the front, or hidden behind the kick-strip at the front of the washing machine (if fitted).
Is there a filter in my top load washer?
“Top loaders tend to have filters on the valves,” said Amber Peabody, Service Manager at Dunnett Inc. The valve filters sift the water going in and out of the pump and hoses. If you do happen to have a removable filter, consult your owner’s manual on how to properly remove it.
What happens if you don’t clean washer filter?
A clogged washing machine filter will also develop mold and mildew if it isn’t cleaned regularly. Spores will get into your clothes during the wash and cause allergic reactions if you’re not careful. The machine will have a shorter lifespan without regular cleaning or maintenance.
Where is filter on top load washer?
Top Load Washer – Lint / Pump Filters
There are 2 crescent-shaped Fine Mesh plastic lint filters in the bottom of the wash basket under the agitator.
During drain down and spin, the water forces the lint off the bottom of the filters and down the drain.
These filters should never require cleaning or replacement.
Where is the lint trap on a Maytag top load washer?
Typically, the washer’s trap is at one of these three spots:
At the end of the washer’s drainage hose.
In the center of the washer’s agitator.
Along the drum’s rim of your washer.
Where is the drain pump filter on a Maytag top load washer?
Open the dispenser drawer by pulling on the handle at the base of the washer. This will reveal the drain pump filter.