An unbalanced load of laundry is one of the most common causes of an inadequate spin cycle. Sometimes clothing can settle on one side of the drum, throwing off the motion of the washing machine. (This happens most often when washing large and heavy items like comforters or heavy coats.)
Why is my washer barely spinning?
Here are a few common reasons a washer won’t spin: The washing machine is too full. The load is improperly balanced. The washer itself isn’t balanced correctly.
How do you fix a GE front load washer that won’t spin?
The first thing to check when a GE front load washer won’t spin is the belt and pulley. Remove the back panel off the washer to access the belt and pulley. Check to see if the belt is worn or broken and if so, replace it. Sometimes the belt will work its way off the pulley.
Why is my GE washer spinning slow? – Related Questions
How do you run a diagnostic on a GE front load washer?
How do you reset the spin cycle on a GE washer?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
How do I force my GE washer to spin?
Why won’t my GE washer agitate or spin?
If the washer is not agitating, you may need to reset your washer motor. If your washer senses a power spike, an unbalanced load or disruption in power, it will send a fault code to the motor and may require the motor to be reset.
Why is my GE washer not draining or spinning?
This usually indicates the washer took too long to pump the water out. There may be a clog. Press Start to resume the cycle or you can select Drain & Spin and press Start. If the washer drains properly, then the clog has likely cleared.
How do you fix a washer that won’t drain and spin?
What to Do When Your Washing Machine Won’t Drain
Perform a Master Reset. Unplug your washer for about one minute.
Test the Lid Switch Assembly.
See if the Drain Hose is Kinked.
Check the Drain Hose or Pump for Clogs.
Clean out the Coin Trap.
Check the Water Level Control.
Schedule Washing Machine Repair.
How do I know if my washer drain hose is clogged?
Start by running your washer through a drain cycle. Observe the washing machine as it pumps water into the hoses and up into the standpipe. If you see water back up and out of the standpipe, your washer’s drain is most likely the issue.
How do I know if my drain pump is clogged?
Remove the drain hose by unscrewing the clamps holding it to the pump outlet. Look for blockages inside the hose, says Family Handyman. If you don’t see any, the pump may be blocked or faulty. To check it, you have to disconnect the belt connecting it to the drive motor.
How do you unclog a washer drain tube?
How do you unclog a front load washer drain?
Is there a way to force my washer machine to drain water?
Try the spin cycle
If your machine allows it, try manually setting it to the spin cycle and running it to see if it drains. You may also try restarting the entire wash cycle to see if it works.
Where is the coin trap on my GE washer?
How do I clean the filter on my GE front load washer?