Where do you put the detergent in a Whirlpool top load washer?
•
How do you use the detergent dispenser on a Whirlpool washer?
Where do you put liquid detergent in a top load washer?
Pour detergent in the dispenser or, if there isn’t one, directly into the tub before adding clothes. Always follow the instructions on the packaging when measuring. If your washer is High-Efficiency (HE), only use HE detergent.
Why is my Whirlpool load and go not dispensing detergent?
If the Load & Go™ dispenser runs out of liquid HE detergent, and the Load & Go™ system is enabled, no detergent will be available for dispensing. If the Load & Go™ dispenser runs out, the first load after being refilled will not have detergent.
Where do you put the detergent in a Whirlpool top load washer? – Related Questions
Why isn’t my washer dispensing the detergent?
When the detergent you added to your washing cycle is not dispensed completely into the washer tub, it may be caused by three major reasons: the type of detergent you are using,the amount of detergent you applied,a maintenance related issue.
Why is my soap dispenser not pumping?
If you are trying to use your soap dispenser and the trigger stays depressed and doesn’t let you pump the dispenser the spring in the pump mechanism may be jammed. You can unscrew the pump and try to get to the spring. If you cannot get to the spring you will most likely need to replace the pump.
Why is my Whirlpool dishwasher not dispensing soap?
How do I reset my Whirlpool load and go washer?
How do I reset my Whirlpool load and go?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP.Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.
How do I fix the soap dispenser on my Whirlpool dishwasher?
What triggers a soap dispenser?
Infrared sensors detect infrared energy that is emitted by one’s body heat. When hands are placed in the proximity of the sensor, the infrared energy quickly fluctuates. This fluctuation triggers the pump to activate and dispense the designated amount of soap.
Can you just throw a pod in the dishwasher?
Don’t just toss a tablet or pod into the dishwasher.
Don’t just throw it in there. Instead, dishwasher tablets or pods must be placed in the detergent dispenser compartment. If the tablet is placed directly in the unit, it’ll dissolve before the wash cycle even begins.
How do I get my automatic soap dispenser to work?
How do I reset my automatic soap dispenser?
Reset Your Amazon Smart Soap Dispenser
Press the power button 5 times. You will see a red blinking light. A blue light blinks when reset is complete.
Set up your Amazon Smart Soap Dispenser in the Alexa app.
Why is my soap dispenser door not opening?
When your dispenser doesn’t open and there’s nothing wrong with the door or latch, the fault might be with the wax motor which is meant to track timers and trigger the soap dispenser when needed. You may need to replace this wax motor or hire a professional to take care of the whole job for you.
How do you activate a soap pump?
How do you prime a soap dispenser pump?
To prime the pump
Use your thumb or finger to cover the hole at the bottom of the dispenser where the soap gets dispensed out of. While still covering the hole, push the button all the way in. While still covering the hole, let the button depress naturally. All done!