Where are the shipping bolts on a GE front load washer?

Do front load washers have shipping bolts?

All manufacturers ship front loaders with the shipping bolts inserted to avoid internal suspension and structural damage to the washer during transport. Retailers leave the shipping bolts in the front loaders until the unit is delivered to the Consumer.

What happens if you move front load washer without shipping bolts?

Moving a washing machine without transit bolts will run the serious risk of damaging your machine, so we strongly advise against it. Washing machine transit bolts are a vital piece of equipment required to move your washing machine securely. A washing machine is a complex piece of equipment with many moving parts.

What happens if you don’t remove shipping bolts from washer?

You need to remove the shipping bolts. If the four shipping bolts of your machine are still attached to the back of the washer, they will cause a loud noise and vibration during the operation of the machine; which can lead to a permanent damage of the washer.

Where are the shipping bolts on a GE front load washer? – Related Questions

What happens if transit bolts are left in washing machine?

The shipping bolts clamp the spring suspension system into a locked position and hence prevent it from being damaged during transit. If you don’t remove them, it will have no suspension system so will vibrate VERY badly when you run it.

Do all new washing machines have transit bolts?

All new washing machines are fitted with a transit bolts to protect the machine against damage in transit. Transit locks and bolts must be removed before you use your appliance.

Do I have to remove shipping bolts?

The transit bolts need to be removed when the appliance is being installed. They are designed to hold the drum in a fixed position while being transported.

Should I keep washing machine transit bolts?

The transit bolts need to be removed when the appliance is in place. They are designed to hold the drum in a fixed position when being transported. Failure to remove this will void the warranty, so please refer to the appliance manual for additional guidance.

Do you need shipping bolts to move a washer?

What Do You Need to Move a Washing Machine? Before moving a washing machine, make sure you have shipping bolts or a foam core, an appliance dolly or hand truck, a wrench or slip-joint pliers, a bucket and some packing tape.

Do you need shipping bolts for washer?

How do you stabilize a front load washer for moving?

So How Do You Stop Your Washing Machines from Moving?
  1. Make sure the washing machine is level. Figure this out with a good old-fashioned bubble level.
  2. Attach some non slip, anti-vibration pads to the bottom of your washer’s legs.
  3. Take precautions to balance your washer load every time you do laundry.

Why do shipping bolts make washer shake?

If the drum does not wobble, the shipping bolts are likely still holding it in place, which can cause the whole washer to shake instead of just the drum inside.

How do you install shipping bolts in a front load washer?

What order do washers and bolts go in?

The lock washer should be placed under your threaded fastener – i.e., underneath a nut or the head of a screw or bolt. In assemblies where you have a nut and a bolt, the washer should be placed between the nut and the head of the bolt. You can then tighten the threaded fastener as normal.

Are all washing machine shipping bolts the same?

Some brands of washing machines may have shipping bolts that are all the same length, and any shipping bolt can be used in any hole.

How do you put transit bolts back in washing machine?

Push a transit bolt into the transit bolt hole on the back of the washer. Make sure the shaft washer, on the bolt, is in place near the head of the shaft so you don’t scratch or damage the back of the washing machine. The washer also dampens vibrations during transport.

How do you install shipping bolts?

How do you install spring bolts?

Leave a Comment