If the washer is running, press the “Start/Pause” pad once to interrupt the cycle, then select “Drain and Spin” and press the “Start/Pause” pad again. If the “Stop” pad has been selected and the washer is still full of water, select “Drain and Spin” and then press “Start”.
How do you fix a washer that won’t spin?
If the drum stops spinning mid-cycle, try stopping the machine, draining the water and rearranging the laundry. You might be using too much detergent or an inappropriate type for your appliance. In this case, your washing machine will stop the spinning cycle and try to absorb the excess foam in its drum.
What would cause my GE washer to not spin? – Related Questions
How do you reset the spin cycle on a GE washer?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
Why is my washer just filling with water and not spinning?
If your washer fills with water but doesn’t agitate, the problem is likely to be a faulty lid switch, a broken belt, or a problem with the motor. (Note: Direct-drive washing machines do not have belts.)
How do I reset my GE washer?
If your washer isn’t working, disconnect it from the power source for one minute.Afterward, plug it back in and quickly lift and lower the lid six times within 12 seconds. And this should reset the motor so you can properly start a cycle.
Why is my washer only filling with water?
If your washer is filling with too much water, the two sets of contacts on the water level switch may have fused. Or there may be a leak in the pressure hose or air dome tube, which connect the switch to the tub.
What to do if washer fills with water then stops?
The lid must engage the lid switch to allow the washing machine to continue through the cycle. If your washing machine fills with water but fails to advance through the cycle with a closed lid, remove and replace the lid switch.
Is there a reset button on my GE washer?
There is No Dedicated Reset Button
Some washing machines and other forms of technology come with dedicated reset buttons; however, GE does not build these buttons into its washers. You will need to manually reset the washer by disconnecting the power and then plugging it back in or turning the power back on.
How do you bypass the water level sensor on a GE washing machine?
Here is a simple way to do this:
Let us say you have 2 lbs of clothes.
Add the 2 lbs of clothes in the washtub.
Before commencing the wash cycle, pour 4 lbs of water over the clothes and let water to soak into the fabric.
Start the wash cycle.
You have successfully bypassed water level sensor.
How do you unclog a washing machine valve?
How do I know if my washing machine pump is clogged?
What to Look Out For. The number one sign of a clogged drain affecting your washing machine is finding water inside the unit after the washing cycle is complete. During the cycle, water is flooded into the chamber of the machine, mixing in with the detergent to clean your clothing.
How do I know if my washing machine pipe is clogged?
To test this, remove the drain hose attached to the washer and make sure it is clear. An easy way to check that the drain hose is clear is to blow air through it. If nothing is obstructing the drain tube, the problem is most likely at the washing machine pump.
How do I know if my water inlet valve is clogged?
You will know that your washing machine water inlet valve is bad if the washer doesn’t run, won’t fill properly, or washes at the incorrect water temperature.
How do you test a GE water inlet valve?
How much does it cost to replace a water inlet valve on a washing machine?
A washing machine inlet valve replacement costs $95 to $190. This valve connects the hoses needed for the unit to fill with water. Signs of a faulty inlet valve is that no water or only a small amount of water is filling the tub.