It’s recommended you always keep a washing machine in an upright position. Laying a washer on its side can cause the inner and outer tubs to bump against each other, which can loosen support pads or damage the suspension.
How do you transport a washing machine?
Wrap your washing machine in three to four moving blankets until it is completely covered and padded. Hold the blankets in place with a cord or packing tape. Next, get your helper or helpers to carefully lift your machine onto a dolly. Secure the washer to the dolly with ropes.
Can a washing machine fit in an SUV?
After all, you aren’t worried about damaging it now. In this case, most hatchbacks, estate and SUV cars can accommodate a washing machine. Just make sure you drain the water from the hose and lay it down an old blanket. In any case, make sure you get some help moving your washing machine to your car or a van.
What happens if you move a washing machine without transit bolts?
Moving a washing machine without transit bolts will run the serious risk of damaging your machine, so we strongly advise against it. Washing machine transit bolts are a vital piece of equipment required to move your washing machine securely. A washing machine is a complex piece of equipment with many moving parts.
Can you lay a washing machine down to transport? – Related Questions
What to do before moving a washing machine?
Steps for moving a washing machine
Clean it.
Shut off the water supply.
Turn off the power.
Unplug it.
Disconnect and drain the hoses.
Remove water hoses from the washing machine.
Keep the drain hose attached.
Clean the outside.
Do top load washing machines have transit bolts?
Of course it does. These are to be removed by the installer or whomever does the installation. The bolts are worth saving somewhere if you ever move, or if you sell the washer to someone else for them to move. Sorry, there was a problem.
Do you need shipping bolts to move a washer?
How can I move my washing machine without damaging floor?
First, tilt the appliance backwards enough to slip a thick piece of cardboard (or a piece of carpet) under the two front legs and as far back to the back legs as you can. Next, wiggle the appliance forward a bit until the back legs sit on the cardboard.
What happens if you run washing machine with transit bolts?
The bolts can rip sections off the outer tank, tear through the outer casing and cause massive damaging vibrations to be sent through the room in which the washing machine is installed. In other words, by not doing as instructed you risk major damage to your washing machine.
Can you put transit bolts back in a washing machine?
These bolts must be removed before the washing machine is used. Ordinarily, unless there are any special instructions, the bolts will simply unscrew as normal and you can simply pull them out.
Can I move a washing machine with a sack truck?
By far the best piece of industrial equipment for moving a washing machine is a heavy-duty sack truck with a long toe plate. The long toe-plate slides further underneath the machine making it less likely to fall off the truck on first tipping. It’s important also to consider the capacity of the sack truck.
Why do shipping bolts make washer shake?
If the drum does not wobble, the shipping bolts are likely still holding it in place, which can cause the whole washer to shake instead of just the drum inside.
How do you transport a Whirlpool washer?
Why is my washing machine moving violently?
If your washing machine is shaking violently, the culprit may be inside: check if the washer is overloaded or if a bulky item is causing it to become unbalanced. If all is well on the inside, it’s also possible that the washer is unlevel or unbalanced due to improper installation or uneven floors.
How do you stabilize a washing machine?
6 Tips to Stop Washing Machine Vibration
Check that your loads are balanced.
Check the the floor and machine are level.
Ensure You Have a Sturdy Floor.
Check Your Stacking Kit.
Purchase Washing Machine Vibration Pads.
Call in Some Reinforcement.
How do you stabilize a top loading washing machine?
How do you stabilize a front load washer for moving?