Simpson is a no-gimmicks, fuss-free manufacturer of both top loader and front loader washing machines. The brand was based in Adelaide for almost 100 years, before it became part of the Swedish Electrolux group. Nevertheless, Simpson still makes a range of quality washing machines for sale here in Australia.
Is SIMPSON a good brand?
Almost every unit of SIMPSON looks and performs like a commercial-grade washer, whereas they can be a great tool for your residential tasks as well. Typically, they are much stronger and durable than 95% of the brands available in the market. Yes, there are dozens of reasons that made Simpson lead the industry.
Who manufactures SIMPSON?
Electrolux
Why does my SIMPSON pressure washer keep shutting off?
SIMPSON pressure washers are designed to ensure you do not damage the engine or any of the mechanical components. Generally, the reason your SIMPSON pressure washer just shut off is because it has run out of gas or oil. ALWAYS check the oil and gas level of your pressure washer every time you plan to turn it on.
Does SIMPSON still make washing machines? – Related Questions
How long can you run a Simpson pressure washer?
Be sure to turn off your machine if you take breaks longer than 2-3 minutes.
What is the most common problem with pressure washers?
Many pressure problems begin and end at the unloader. A cracked o-ring, dirt caught in the spring or a stuck shaft are the most common issues solved by simply removing the unloader and cleaning/looking for issues.
What does it mean when your washer keeps stopping?
If a washer stops mid-cycle, it could be because the pump or the motor that runs it has failed. When this happens, it cannot remove the water efficiently, pump water in, and thus the sensors won’t allow it to move to the next cycle.
Why does my washer randomly stop working?
These include an incoming power problem, a damaged power cord, a malfunctioning door lid switch or lock, a defective user control board or timer, a broken drive belt, or a faulty or obstructed drain pump.
How do you master reset a Simpson washing machine?
If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds.Then, run the rinse/spin cycle without clothing to see if your problems are resolved.
How do you adjust the Simpson unloader valve?
How do I know if my unloader valve is bad?
Water leaks and inconsistent behavior are also signs of a potential failure in the near future. González: The typical signal when there is an unloader malfunction is a reduction of flow through the nozzle, which results in pressure loss. Dean: Typical symptom of an unloader failure is a sudden smooth pressure loss.
How do you unstick a unloader valve?
How long does a unloader valve last?
As we mentioned earlier, pressure relief valves that are properly maintained can last for up to 30 years. In most cases, it’s important to look at the “why” behind pressure relief valve failure, rather than just replacing the valve in question.
Where is the unloader valve on a Simpson pressure washer?
Where is unloader valve located?
Where Is the Unloader Valve Located? If you own a smaller reciprocating air compressor, you’ll likely find the unloader valve mounted on or inside the pressure switch. When the switch shuts the compressor off, it actuates the valve.
Can you run pressure washer without unloader valve?
However, if the pressure washer gun is disengaged, and there is no unloader valve to redirect the pressurized water, the pressure would continue to build. It wouldn’t take long for the pressure to exceed the components’ PSI limitations, and damage the pump, gun, or hoses.
Can you adjust the pressure on a Simpson pressure washer?
This pressure washer is equipped with an additional feature that allows the pressure setting to be adjusted. a. To lower the pressure, turn the unloader control knob (located under the hot water tank) counterclockwise to the desired pressure.