A clogged drain pump is one of the most frequent reasons for your GE washing machine being stuck on sensing. The drain pump could be blocked with accumulated gunk, dirt, mineral buildup, or sand.
How do you reset a GE washer sensor?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
How long does a washer stay on sensing?
These sensing spins may take 2 to 3 minutes before water is added to the load. The washer will then move the load briefly, pause to allow water to soak into the load, and resume adding water. This process may repeat until the correct amount of water has been added to the load.
Why does my washer stop at sensing fill?
There are several possible reasons why your washing machine may be stuck on sensing fill. The most common reasons include overloading of the drum, a clogged inlet screen, a faulty inlet valve, or a failure of the main control board.
Why is my GE washing machine stuck on sensing? – Related Questions
How do you bypass a washing machine sensing?
Here is a simple way to do this:
Let us say you have 2 lbs of clothes.
Add the 2 lbs of clothes in the washtub.
Before commencing the wash cycle, pour 4 lbs of water over the clothes and let water to soak into the fabric.
Start the wash cycle.
You have successfully bypassed water level sensor.
How do I put my GE washer in diagnostic mode?
How do I reset my Whirlpool auto load sensing washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP.Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
Why is the sensing fill light flashing?
See the following troubleshooting link: http://products.geappliances.com/appliance/gea-support-search-content?contentId=16539 If the fill light flashes, check your house water supply. As soon as the light starts to flash, the washer will initiate a 4 minute lock-out period.
How do I reset the sensor on my LG washer?
What does sensing fill mean?
SENSING/FILL Light is on
When the Start/Stop button is pressed, and the Water Level knob is set to Auto Sensing, the washer will fill and begin sensing to determine load size and balance.
How does GE auto load sensing work?
What is the purpose of sensing?
A sensor converts the physical action to be measured into an electrical equivalent and processes it so that the electrical signals can be easily sent and further processed. The sensor can output whether an object is present or not present (binary) or what measurement value has been reached (analog or digital).
How does a sensing washing machine work?
In a washing machine, the Hall Effect sensor is mounted onto a printed circuit board in the electronics panel or onto the frame of the appliance, and a magnet is mounted on the rotating dial. When the dial is turned, the magnet rotates and changes the magnetic field detected by the Hall Effect sensor.
How do you test a washing machine sensor?
How much are washer sensors?
₹449.00 FREE Delivery.
What does auto sensing mean on a GE dishwasher?
This cycle automatically senses the soil level and adjusts the wash cycle accordingly. Press the SELECT CYCLE button until you see AUTOSENSE on the display.
How do I fix the sensor on my GE dishwasher?
How do I reset my GE dishwasher control panel?
Hold the Start button now for five seconds.The Start button should start flashing.Finally, hold the Start and Select Cycle button down for five seconds. The dishwasher control panel should now light up, and the dishwasher should be ready to go.